Mirrored console table – Use a drill to start holes for eyehooks so the frame can not crack. Run picture wire back and forth between eyehooks several times, twisting the wires together as you go. Table top wire turning the two ends together. Place the mirror on the floor and pull the wire rope upward. Measuring the distance between the upper frame and the highest point reached when the wire is stretched. Measure to find the center mirrored console table. Hang a plumb line from a string and hold chain against the wall. When the sinker is installed in the center console table, mark the wall with the string as your guide. Make an assistant to assess if you have high enough mirror on the wall. Mark that spot on the wall along the vertical line you did in Step 3. From this mark, measure and mark down the distance between the top of the frame and picture wire hanger you have installed . Place the nails triple hanger so that the hook on the wire go is on the mark you just made. Due to the design of the suspension, nails go into the wall at an angle. Hangers nails triples mirrored console table are available in stores home improvement, craft shops and stores drive image.